3 Tricks to Save Time and Money Re-Spooling Fishing Reels

This will keep the line in tight loops without any slack. You will get different answers depending on which angler you ask as to which is the best knot to use to tie the line onto the fishing reel spool. Some will say an overhand knot works just fine and others will say you need to tie an arbor knot.

Always apply light pressure to your line while you load it. If you don’t the line will go on loose and end up becoming tangled later. If the line is twisting, strip some of the line back off of your reel and realign your spool and line. To make sure that the line enters the reel properly, lay the spool flat on the floor with the label facing up. Your spool should line up so that the line comes off of the spool the same way it will be going into the reel. But you should ensure that there’s enough tension applied to the line to prevent twists or tangles.

For Baitcaster rods, you’ll need to stick a pencil through the spool and have someone else hold it. Alternatively, purchase a reel spooler or make one by placing the spool on a screwdriver pushed through a cardboard box. You can use a lure, swivel, or a clip to secure the free end of your line. This will prevent the line from slipping through the guides.You can also wrap a rubber band around the spool.

Close-faced and Spincast are different names for the same reel. You’ll know you have one if it has this cover you need to unscrew to reach the reel’s spool. Lightly grip the line between your thumb and your index finger. Use your free hand as you hold the rod in your other hand.

Note that when you see a line twist while restringing, you have to start anew. If you have already done this, do it again, and try to take time to notice twists. You can learn how to restring a fishing reel by organizing your materials first. If you’re fishing with floating baits or live baits, the best line choice is a monofilament line. The single line provides a more flexible line that can increase your chances of securing the bait inside the fish’s mouth. I cover everything from the best fishing rods, reels, and more.

Keep adding line until you are within about 1/8 of an inch of the spool edge. If you add too much, the line may billow off uncontrollably during the cast, but if you underfill the reel you will substantially limit your casting distance. It’s almost always better to go higher and then take line off as needed. The one exception to this rule is when you want to use braid as your primary line with a fluorocarbon leader. This minimizes line stretch as well as line twist, and allows you to change just a limited section of line each day while your main line stays supple for months. You can use a leader as short as 7 or 8 feet, or up to slightly longer than your longest cast for this process.

The easiest way to do this is to hold the reel the same way you would if you were actually fishing. Turn the wheel at least 2 to 3 times to determine if the reel turns clockwise or counterclockwise. This is the way the line will be spooled onto the reel; the opposite direction is the way the line will peel off the spool when you cast. When you stop reeling, you stop twisting the line too.

Website | + posts

Dion Liriano is a 51-year-old American zookeeper who has retired from the business. He was once a highly successful director of the Zoo and Aquarium, but he has since hung up his gloves and moved on to other ventures. Dion's passion for animals began at a young age, when he would help his father care for their family pets. This love grew exponentially when he started working at the zoo; Dion quickly became one of the most experienced keepers in the business. He credits his success to the relationships he built with both staff and animals over the years.

Leave a Reply

Your email address will not be published. Required fields are marked *