Fishing rig
The basic bobber rig takes a bobber, a sinker, and a hook. The bobber is attached high on the line, about 24” or so to where the hook is tied on. Near the hook, there will be a sinker or a weight attached to the line. This will allow the hook with your bait to sink into the water while the bobber stays on top. This rig consists of a swivel that attaches the main line to a leader that attaches the sinker. On the leader that attaches the sinker, you will add 2 additional leaders of line by tying a dropper loop onto the leader.
Unfortunately, 5 wire rigs aren’t legal in all states, so you will need to make sure the state in which you are fishing will allow 5 wire rigs to be used. As long as you’re not fishing in a tournament, you can use an umbrella rig. Umbrella rigs have been banned in most fishing tournaments because they are so effective. To keep the competition fair, umbrella rigs are typically not allowed. Drop shot rigs should be cast directly from the side of the boat and straight down to the area below.
One end of the three-way swivel will be attached to the main fishing line, one end will be attached to a sink, and one end will be attached to a hook. The Neko rig is a unique rig and it’s becoming very popular among many anglers. As you can see in the tank to the left, the hook is in the center of the bait and the weight is at the head of the bait. In this case, it’s a screw that is screwed into the head of the worm. Tie a 6- to 8-inch piece of leader to the snap swivel using one of the fishing knots. Tie a three-way swivel to the end of the abovementioned leader.
It will work in freshwater as well, although, most freshwater anglers probably don’t even know what a popping cork looks like. Just because you can tie a lot of different things to a line, doesn’t mean that your fishing rig needs to be complicated. Most freshwater fishing rigs are relatively simple and used for specific fishing techniques. Keep in mind that the best fishing rigs are those that attract the type of fish you’re seeking.
Florida-Sportsman what is a good pike fishing rig for trolling a dead bait behind a boat?: like the question above… http://bit.ly/bznq86
— Floridasportsman (@floridasport) October 14, 2010
The double jig rig is probably most popular among crappie anglers, but anglers use this rig for many other fish as well. Saltwater anglers use a double jig rig with just a plain jig head and they will add live bait or soft plastics. Panfish anglers like to target perch, bluegill, rock bass and other types of panfish that will school up over deeper water in the summer months. Each type of rig has a different purpose, and some rigs may have several names. Other rigs work well for specific species and are referred to as bass rigs, flounder rigs or catfish rigs. You can also learn how to set up fishing rigs that can be used for multiple species.
One hook from the forward treble usually is positioned at the minnow head, or just behind it. The second hook is barbed about mid-bait, or sometimes at the tail. The beauty of the rig is the convenience of carrying small, party-style balloons in a tackle box, as they can be inflated quickly when needed. It’s most often used with live bait fished from a stationary position, such as a dock, jetty, bridge, break wall, shoreline, dam, or anchored boat. The beauty of this dropper rig is that split shot can be added or removed quickly depending on the depth and current you are working. If you get snagged on the bottom, the dropper typically breaks off, and you won’t lose the entire rig.
When maneuvered correctly, stick baits dart back and forth in a zig-zag pattern known as “walking the dog,” which bass and many other big fish find irresistible. They’re best reserved for calm, clear waters to attract maximum attention. A light tugging action is all it takes to send them skittering along. This constant movement makes them perfect for fishing rough, choppy waters or calmer areas during rainstorms.
Finally, you will take the body of the lure and insert the hook at the location where the lure will be stretched out perfectly, concealing the point of the hook. The sinker drags the line to the bottom while the three-way swivel allows the line with the hook to float a little bit above. This allows the bait to float naturally in the water and makes it noticeable for bottom-feeding fish.
Thread the narrow end of the weight onto the line carefully and slide it down 2–3 feet (0.61–0.91 m) to give yourself plenty of workable line. As you prepare for the next step, keep a firm hold on the loose end of the line to keep the sinker from slipping right back off. It’s possible for both live and dead bait to come loose quite easily. Be prepared to re-bait your hook several times during a single trip, if necessary. The improved clinch knot makes a wonderful all-purpose knot.
Use an improved clinch knot to secure the hook to your line. Tie a worm hook onto the end of your line using an improved clinch knot. Round-bend and wide gap hooks tend to work best for a standard Texas rig. Guide the line through the eye of the hook, then double it over on itself to start your knot. Once it’s nice and tight, snip off the excess line on the tag end with a pair of pliers.
Dion Liriano is a 51-year-old American zookeeper who has retired from the business. He was once a highly successful director of the Zoo and Aquarium, but he has since hung up his gloves and moved on to other ventures. Dion's passion for animals began at a young age, when he would help his father care for their family pets. This love grew exponentially when he started working at the zoo; Dion quickly became one of the most experienced keepers in the business. He credits his success to the relationships he built with both staff and animals over the years.